Skip to main content

Administration

 

Request and Report Forms​

It is important to establish good general shop safety rules for everyone who enters or uses the shop area. Implementing general shop safety rules will keep everyone healthy and provide the most productive environment for working or learning.

Post the rules where they can clearly be viewed at all times. Additionally, provide shop users with a written copy of the rules and discuss them to answer any questions or resolve any confusion shop users might have.

 

General Shop Safety Rules​

 

In Case of Inury or Contact with Harmful Cemicals

  • In case of injury, no matter how slight, report it to the shop supervisor. The campus emergency phone number is 8-911.
  • Contact with harmful chemicals should be reported immediately. Notify campus rescue at 8-​911.

Report All Near Misses Incidents to Environmental Health and Safety (EHS) at x8040

Report of Safety / Health Hazard and Near Miss

Near misses are warning signals to potential accidents and injuries.

Back to Top​

Personal Protection

  • You must wear safety glasses, cover goggles, or a face shields before entering the shop.
  • Shoes must be worn in the shop. No one wearing sandals will be allowed to enter any shop area. The minimum footwear must cover the entire foot.
  • Do not wear ties, loose clothing, jewelry, gloves, etc. when operating shop equipment
  • Wear appropriate clothing for the job. Do not wear short sleeve shirts or short pants when welding.
  • Follow all appropriate precautions when working with solvents, paints, adhesives or other chemicals. Use appropriate protective equipment. Review the material safety data sheet (MSDS).

Back To Top

 

Before You Get Started

  • Do not work in the shop if you are tired, or in a hurry.
  • Think through the entire job before starting.
  • If you have never worked with a particular material, check the materials safety data sheet (MSDS) for any specific precautions to be taken while working with the material. Also, ask the shop personnel before cutting any unusual material.
  • Heavy sanding and painting should only be done in well ventilated areas.
  • Check the condition of power cords and plugs on portable tools before using them. Do not use a tool that has a worn or damaged power cord/plug.

Back To Top

Conduct in the Work Area

  • Never engage in horseplay in the shop areas.
  • Do not drink alcoholic beverages before or during a work session in the machine shop area. Do not bring food or snacks into the shop.
  • Don’t rush or take chances. Obey all safety rules.

Back To Top

 

Operating Machinery and Power Tools

  • Do not operate any equipment unless you are familiar with its operation and you have been authorized to operate it. Questions regarding the use of equipment should be directed to the shop supervisor.
  • No work using power tools is to be performed unless at least two people are:
        1. In the shop area and
        2. Can see each other.
  • Before starting a machine, always check it for correct setup and always check to see if the machine is clear.
  • Machines must be shut off and locked-out before servicing.
  • All machines must be operated with all guards and shields in place.
  • Do not use your bare hands to remove chips and shavings from the machine. Use a brush or hook.
  • Never use a rag near moving machinery.
  • Do not strike a hardened tool or any machine with a hammer.

Back To Top

 

Cleaning Up​

  • Use the shop vacuum cleaner to remove chips. Never use compressed air guns to clean clothing and hair.
  • Keep the floor around machines clean, dry and free from trip hazards. Do not allow chips to accumulate. Use the shop vacuum cleaner.
  • Practice cleanliness and orderliness in the shop areas. Use the shop vacuum cleaner. Clean-up before you leave!
  • Always store oily rags in an approved metal container.

Back To Top

Environmental Health and Safety
Last updated 8/21/2015 4:42 AM